How to Achieve Potable Harvested Rainwater with UV Disinfection

file0002019685404UV disinfection is the most common method used in residential rainwater collection systems.

UV light is generated by  supplying voltage across a mixture of gas, causing a discharge of photons, disrupting the DNA of microorganisms which prevents them from reproducing.  If the microorganism cannot replicate, it cannot infect, so viruses, bacteria, Cryptosporidium and Giardia cyst threats are effectively reduced.

A residential UV system typically consists of a power supply (ballast), a UV lamp housed in a Quartz sleeve inside a stainless steel chamber. The flow is directed close to the UV light while passing through the chamber. Effects of turbidity or clarity of the water before entering the chamber must be reduced by proper filtration upstream. Sediment and carbon filtration is used to reduce solids and solution contaminants, which can reduce the effects of UV disinfection. Filtration and UV bulb most be routinely changed in order for all to work effectively. It is recommended to follow manufacturer’s instructions closely, and filters should be changed out as needed.

Some UV systems offer an alarm or sensor with solenoid shut down if the UV system is not working properly. A class “A” UV is the only system considered to purify water that has NOT been deemed “safe to drink”, therefore caution is recommended in the use of a class “B” filter which maybe more tempting to use because of price. The difference between the two is the dosage of the UV light; the lower dose is not as effective in disinfecting. If a more advanced filtration system is used prior to disinfection, you can increase the effectiveness of the class “B”, but caution must be taken for proper results.

UV disinfection provides a relatively low cost, dependable, efficient, chemical free method of water purification that the homeowner can operate to disinfect his or her water supply.

With proper design, installation, and maintenance, clean, safe, and dependable potable water can be achieved from UV disinfection and rainwater collection.

Ken Blair
A rainwater collection systems designer and consultant, Ken has designed and installed residential and commercial systems, primarily in the northwest United States for more than 10 years and, in 2014, began consulting and managing builds in other states. Ken is an accredited ARCSA Professional Designer / Installer and Life Member, the Northwest Regional ARCSA representative and advisor to its education committee and is available to speak about Rainwater Collection Systems design and builds.

Ken is a United States Navy veteran, having served on active duty during the Vietnam War era.

A career entrepreneur, Ken created a new business focus with a commercial dive company in Hawaii in the mid 1980′s to respond to and clean up oil spills, oil spill equipment training, service and maintenance for the oil co-op service industry. Ken is passionate about having a positive impact on the environment and is also a founding director of BANK-ON-RAIN (2011-2014), whose mission is to create grassroots solutions for rainwater collection for consumption and agriculture in developing areas of the planet.